| INTRO | Read entire label prior to use and use as directed. Shake before use. Complete coverage is key, especially in shaded areas. To prevent phytotoxic burn or browning of foliage, apply when temps are below 90 if possible and not in direct sunlight. |
| 1 | If refilling Wondercide’s ready-to-use sprayer, add 8 oz concentrate and fill to top with water. If using another pre-mix hose-end sprayer, add 10 oz of concentrate and fill to 20 gallon fill line. Higher rates of concentration may enhance results. Attach hose to sprayer and turn on the water. |
| 2 | Turn on the sprayer by moving the the dial to the ON position. |
| 3 | Apply Wondercide every few days until control is established and desired results are achieved. Start at your home and spray the bottom few feet of the siding, then continue into the yard and work your way outward to the property line. Walk at a steady pace and use a sweeping motion, slightly overlapping treated areas. Thorough coverage is important, especially in shaded areas. |
| 4 | Coverage area per 8 oz concentrate in Wondercide’s ready-to-use spray bottle or 10 oz concentrate in another hose-end sprayer: To kill fleas and mosquitoes: treats 5,000 sq ft. To kill and repel ticks, and repel mosquitoes: treats 2,500 sq ft. For ongoing control, apply as needed depending on pest pressure. |
| 5 | Electrolyzed Water (H2O), Sodium Chloride (Salt), Pure Hypochlorous (0.02%) |
| 6 | If you’re using a compression sprayer for smaller areas, use .5 oz (½ oz) per gallon of water. |
| 7 | To ensure you’re treating your pest problem indoors and out, use with with Flea & Tick Pets + Home. |
| NOTE: STUCK SPRAYER? | First, try turning down the pressure on the water by partially closing tap coming from the house. Too high of water pressure can make it hard for the effect to prime and pull solution up the straw and out of the bottle. Secondly, squeeze the bottle. This helps prime the effect. |
| NOTE: STUCK SPRAYER? | If there's still an issue, remove the sprayer top from the bottle which will release any pressure that can sometimes build up inside the bottle. Next, soak the sprayer and straw in warm water for 5-10 minutes. Clogs are rare but may still happen on occasion. The warm water will break up any solution that may be causing a blockage. Once done, reattach the sprayer, shake well, and then attach the hose and begin spraying. |