CopperMine CT-102 Manual Copper Wire Stripper Tool, Portable Handheld Wire Stripping Tool for Scrap Copper Recycling

Specifications:

• Good for most wires from 24 AWG (3/64") and up, either solid or stranded.
• Great wire stripper for on-the-go users looking to strip small sections of scrap wire.
• This machine may not be able to strip wires thicker than 10 AWG, especially with tougher insulation.
• Product Size: 3-1/2" x 1-3/4" x 2"

How to Hold:

• Hold the tool with your dominate hand.
• Position the machine between your thumb and pointer finger.
• Squeeze the stripper and let the blade tip enter the hole.

Set Cutting Depth:

• Adjust the blade depth to an estimated level based on the wire you are stripping by turning the adjustment screw.
• When adjusted properly there should be minimal pulling force and the blades should glide across the insulation.
• For difficult wires the blade angle can be adjusted by slightly loosening the screw holding the blade, repositioning the blade, and tightening.

Wire Stripping:

• Choose a hole on the wheel slightly larger than the wire.
• Set the blade tip to the correct height.
• Insert the wire about one inch past the wheel from the back of the machine.
• Pull the wire through the front of the machine, keep pulling until the entire wire has passed the wheel.
• Find the slit and pull the copper out of the insulation.